How to find the tempo of a song
Play the song and tap the round pad on each beat, the pulse you would tap your foot to. On a computer you can press the space bar or any letter instead. From the second tap, the counter shows the tempo in beats per minute; keep going for eight or ten taps and the number steadies.
Under the tempo, the page gives the exact value to one decimal place, the length of one beat in milliseconds, useful for setting a delay, and the Italian tempo marking that usually covers this speed.
How the tempo is calculated
The counter measures the time between your taps and averages the last eight intervals. A single early or late tap moves the result by at most an eighth of its error, so the reading stays stable while still following you if the music speeds up.
A pause of more than two seconds ends the measurement; the next tap begins a new one.
Half time and double time
A fast song can be counted in two ways: 170 BPM on every beat, or 85 on every other beat. Neither is wrong. The Half and Double buttons convert the reading without tapping again. As a rule of thumb, choose the count that makes the snare drum fall on beats two and four.
From the tempo to the metronome
When the tempo is steady, the button under the pad opens the metronome at that tempo. Play along with the click over the recording for a few bars: if the two drift apart, adjust by one BPM and try again. For a tempo that has its own page, such as 120 BPM, the button leads there, with the note lengths in milliseconds.
Questions and answers
How many times do I need to tap?
The tempo appears at the second tap. It becomes reliable after about eight: the counter averages your last eight intervals, which evens out the small irregularities of a human hand.
How accurate is a tapped tempo?
With eight steady taps, usually within 1 or 2 BPM. Recorded music is rarely on a round number anyway unless it was made to a click. If the figure hovers between two values, take the one that suits the piece and check it against the recording with the metronome.
The tempo shown is twice too fast, or twice too slow.
You tapped the eighth notes instead of the beats, or every other beat. It is the same tempo felt differently. Use the Half and Double buttons to switch between the two readings.
Why did the counter start again from zero?
After two seconds without a tap, the next tap starts a new measurement. That lets you move on to another song without pressing Reset. It also means the counter cannot measure tempos below 30 BPM.
Can I tap with the keyboard?
Yes. Any letter, the space bar or Enter counts as a tap, as long as the cursor is not in a form field. Keys are often steadier than a trackpad click.
Updated November 15, 2026