Online violin tuner

Bow or pluck an open string. The tuner shows the string and the gap in cents.

Press Start and play one note.

A4 = 440 Hz

Strings
Display

The sound is analysed on your device. Nothing is recorded or sent. The tuner follows the string you play. Tap a string to hear its note and lock the tuner on it.

Strings and frequencies

String Note Frequency (A4 = 440 Hz)
4 G 3 196.00 Hz
3 D 4 293.66 Hz
2 A 4 440.00 Hz
1 E 5 659.26 Hz

Alternate tunings

How to tune a violin

Press Start the microphone and play the A string, the second from the right as you look at the violin from the front. Violinists tune the A first, then the other strings from it. The needle shows the gap: left is flat, right is sharp. Bring it into the green zone with the fine tuner if the string is close, with the peg if it is far.

Then tune D, G and finally E. The four strings are a perfect fifth apart: G below middle C, then D, A and E going up.

Be careful when you tighten the E string: it is thin, under high tension, and it is the one that breaks. Raise it slowly and stop as soon as the note turns green.

If the peg slips or sticks

A peg that will not hold is the commonest problem when tuning. Push it gently into the pegbox as you turn, so that the taper grips. In dry weather pegs shrink and slip; in damp weather they swell and stick. If a peg slips again and again, a violin maker can fit it properly in a few minutes.

Lowering the string slightly before tuning up frees it in the nut and at the bridge, and the string then holds its pitch better. After any large change, check that the bridge still stands straight: tightening the strings pulls its top towards the fingerboard.

Reference pitch

The standard A is 440 Hz. Many orchestras and most of continental Europe tune to 442 or 443 Hz, and baroque ensembles to 415 Hz. Choose the value under the dial before you start; it is remembered for your next visit.

Auto mode

The tuner recognises the string you play. If a string is more than a tone away from its note, tap its button: the tuner plays the target note and locks on that string.

The same tuner is set up for the viola and the cello. To check a fingered note rather than an open string, use the chromatic tuner.

Questions and answers

Should I bow or pluck the string to tune?

Bowing gives a steady note that the tuner reads best: use a long, even stroke without pressing. Plucking works too, and is easier for a beginner, but the note fades quickly; read the needle in the first second.

When do I use the pegs and when the fine tuners?

Fine tuners, the small screws on the tailpiece, are for corrections of up to about a semitone. Use the pegs when the string is further off. Turn a peg a few millimetres at a time while pushing it gently into the pegbox, or it will slip back.

My orchestra tunes to 442 Hz. Can the tuner do that?

Yes. Set the reference pitch under the dial to 442 Hz, or to any value from 415 to 466 Hz. All four strings follow it.

Is the tuning the same on a small violin?

Yes. Fractional sizes (3/4, 1/2, 1/4 and smaller) are tuned to the same G, D, A and E as a full-size violin. The fiddle is the same instrument and uses the same tuning.

Updated November 15, 2026