Tuners by instrument
- Guitar tuner
- Ukulele tuner
- Violin tuner
- Bass tuner
- Viola tuner
- Cello tuner
- Banjo tuner
- Mandolin tuner
- 12-string guitar tuner
- 7-string guitar tuner
How to use the tuner
Press Start the microphone and allow access when the browser asks. Play one note and let it ring. The large letter is the nearest note, the small number its octave, and the needle shows the gap: to the left the note is flat, to the right it is sharp. When the needle sits in the green zone and the letter turns green, you are within 5 cents of the note.
The tuner is chromatic: it recognises all twelve notes in every octave, from the lowest string of a five-string bass to the top of a piccolo. It works for any instrument that plays one note at a time, and for the voice. If you play a guitar, a ukulele, a violin or a bass, the tuners by instrument show the strings and tell you which one you are playing.
Reading the needle
The dial covers 50 cents on each side, which is a quarter tone. If the needle is pinned to one end, the string is more than a quarter tone away: keep turning the peg in the direction shown under the note until the needle comes back.
Strings go flat more often than sharp. Tune up to a note: if you overshoot, drop below it and come back from underneath, so the string settles against the peg.
The strobe display replaces the needle with moving bands. They drift left when the note is flat, right when it is sharp, and stand still when it is in tune. Some players find a slow drift easier to read than a small needle movement.
Reference pitch
By default the A above middle C is 440 Hz. You can set it anywhere from 415 Hz (baroque pitch) to 466 Hz, with shortcuts for 432, 440, 442 and 443 Hz. The setting is remembered on this device and applies to every tuner on the site.
How accurate is it?
The pitch detection is written for this site and tested automatically on generated signals: within one cent on pure tones from 40 to 2,000 Hz, and within a cent and a half on tones rich in harmonics, where simpler methods confuse the octave. On a real instrument the reading depends on the microphone and the room; expect about 3 cents, which is finer than a guitar holds its tuning.
If you only want to know which note a sound is, the note detector shows it on a keyboard and keeps a list of the last notes heard.
Questions and answers
The tuner does not react. What should I check?
First the permission: the browser asks once, and a refusal is remembered. Click the padlock in the address bar and allow the microphone. Then the input: on a computer with several microphones, the browser may be listening to the wrong one. Finally the distance: play within about 30 cm of the microphone and let the note ring.
What is a cent?
A cent is one hundredth of a semitone. Two notes 5 cents apart sound the same to most people when played one after the other, but beat slowly against each other when played together. The green zone of the dial is 5 cents wide on each side.
Why does the note sometimes jump by an octave?
At the attack of a plucked string, the harmonics are louder than the fundamental for a fraction of a second. The tuner ignores an isolated jump; if it persists, pluck more gently, nearer the middle of the string, and read the needle once the note has settled.
Should I tune to 440 Hz or 432 Hz?
440 Hz is the international standard and what most recordings use. Many orchestras tune a little higher, to 442 or 443 Hz. 432 Hz is a choice some musicians make for its slightly lower sound; it changes the pitch and nothing else. Use the same reference as the people or the recording you play with.
Is my microphone recorded?
No. The sound is analysed inside your browser, on your device, and is never recorded or sent anywhere. Closing the page or pressing Stop releases the microphone.
Updated November 15, 2026