Online cello tuner

Bow an open string and hold the note. The tuner names the string and shows the gap in cents.

Press Start and play one note.

A4 = 440 Hz

Strings
Display

The sound is analysed on your device. Nothing is recorded or sent. The tuner follows the string you play. Tap a string to hear its note and lock the tuner on it.

Strings and frequencies

String Note Frequency (A4 = 440 Hz)
4 C 2 65.41 Hz
3 G 2 98.00 Hz
2 D 3 146.83 Hz
1 A 3 220.00 Hz

Alternate tunings

How to tune a cello

Press Start the microphone. Bow the A string, the thinnest, with a slow stroke in the middle of the bow. The needle shows the gap: to the left the string is flat, to the right it is sharp. Use the fine tuner on the tailpiece to bring the needle into the green zone.

Then tune D, G and C in the same way. The four strings are a perfect fifth apart.

Place the phone or the computer about a metre in front of the instrument. The cello is loud: too close, the microphone saturates and the reading wavers.

Fine tuners first

Reach for the pegs only when a string is more than a semitone out. Turn the peg in small movements, and tune from below the note: if you go past it, loosen the string and come back up. A cello bridge is tall, and large changes of tension can tilt it; glance at it after tuning to make sure it stands upright.

Reference pitch

The A of the tuner is 440 Hz by default. Set it to 442 or 443 Hz if your orchestra or your teacher asks for it, or to 415 Hz for baroque pitch.

The exact frequency of each string is on the cello tuning page. For the other bowed strings, see the viola tuner and the violin tuner.

Questions and answers

What notes are the cello strings?

From the lowest to the highest: C, G, D and A, a fifth apart. The low C is two octaves below middle C, at 65.41 Hz; the A is the A below middle C, at 220 Hz. It is the viola's tuning, one octave lower.

Why does the needle take longer on the C string?

A low note vibrates slowly: the C string completes 65 cycles per second, against 220 for the A. The tuner needs to hear several cycles before it can measure them, so it listens a little longer for low strings.

The pegs are hard to turn. Is that normal?

Cello pegs are large and hold a lot of tension. Loosen the string slightly first, then turn while pushing the peg firmly into the pegbox. For small corrections use the fine tuners on the tailpiece; most cellos have one on every string.

Updated November 15, 2026