Strings and frequencies
| String | Note | Frequency (A4 = 440 Hz) |
|---|---|---|
| 4 | G 3 | 196.00 Hz |
| 3 | D 4 | 293.66 Hz |
| 2 | A 4 | 440.00 Hz |
| 1 | E 5 | 659.26 Hz |
Alternate tunings
How to tune a mandolin
Press Start the microphone. Start with the lowest pair, the two G strings. Mute one with a finger, pick the other and watch the needle: to the left the string is flat, to the right it is sharp. Turn its peg until the needle rests in the green zone. Then mute the string you have just tuned and tune its twin.
Repeat for the D, A and E pairs. The pairs are a perfect fifth apart, from the G below middle C up to the E an octave and a third above it.
Getting the pairs to match
A mandolin sounds in tune only when the two strings of each pair agree. The tuner’s green zone is 5 cents wide on each side; within it, two strings can still differ enough to shimmer. After tuning both strings with the needle, play the pair together and adjust one of them by a hair until the sound is steady.
The E strings are thin and tight. Raise them slowly, and always from below the note.
Auto mode
The tuner follows the pair you play. With eight strings close together it is easy to pick the wrong one: tap a string button to hear the target note and lock the tuner on that course.
The mandolin shares its notes with the violin, and the Irish tenor banjo is tuned to the same notes one octave lower. Frequencies are listed on the mandolin tuning page.
Questions and answers
How do I tune two strings that sound the same note?
One at a time. Rest a finger or the pick against one string of the pair to mute it, tune the other, then swap. When both read in tune, play them together: if you hear a slow wobble, one of them is still a few cents off.
What are the notes of a mandolin?
G, D, A and E from the lowest pair to the highest, a fifth apart: the same notes as a violin. The lowest G is the G below middle C, at 196 Hz.
Which peg belongs to which string?
On most mandolins the four pegs on the upper side of the headstock serve the G and D pairs, and the four on the lower side serve the A and E pairs. Follow the string from the nut to its post before you turn anything: tightening the wrong string is how E strings break.
Updated November 15, 2026